CORRECT CRAFT 200-OB El manual del propietario descargar pdf (Pagina 188)

8-6

Section 8

Propeller

Removal

1. Remove the cotter pin from the propeller shaft and discard.

2. Wedge a piece of 1" x 4" wood between the propeller blade and

the starboard side of the strut and rudder.

3. Remove the nylon locknut and discard.

Use a propeller puller to remove the propeller, then remove the

key from the keyway. Inspect the keyways and key for any damage.

CORC047

• A propeller can be very sharp. Be careful when you

handle it. Wear a pair of protective gloves when

handling any propeller.

• Remove your key from the ignition and remove the

Emergency Stop Switch clip from the switch to

prevent accidental starting of the engine.

• DO NOT reuse the nylon locknut or the cotter pin.

• DO NOT use a damaged propeller. A damaged

propeller can damage your engine and boat.

CAUTION

D-Drive Sec 8_2010:Nautique Ski Sec 8.qxd 7/28/09 9:13 AM Page 8-6

1 2 ... 183 184 185 186 187 188 189 190 191 192 193 ... 227 228

Sin comentarios

CORRECT CRAFT 200-OB El manual del propietario Pagina 188